Other Settings
Setting basic operations
You can make settings for basic operations such as turning the projector on or off in Operation from the Configuration menu.
Press [Menu] button > Extended > Operation
You can make the following settings in Operation.
Operation Settings
Turn the projector on or off by turning the main power
supply on or off or by plugging in or unplugging the
power cable.
Set Direct Power On to On. (Default: Off)
Stop projection automatically when no image signal is
being input and no operations are carried out.
Set Sleep Mode to On. (Default: On) Set the time until the projector enters sleep mode in Sleep Mode Timer.
You can set within a range of 1 to 30 minutes. (Default: 30min.)
Use the projector above an altitude of 1500 m. Set High Altitude Mode to On. (Default: Off)
Start projecting images from the same source as last time
when the projector is turned on.
Set Startup Source Search to Off. (Default: On)
*1
Control the projector from a computer using
communication commands without releasing A/V mute.
Set A/V Mute Release to A/V Mute. (Default: Any Button)
*2
Turn off the confirmation buzzer that beeps when the
power turns on or off.
Set Beep to Off. (Default: On)
*1Because the default is On, the projector automatically detects image signals being input when it is turned on.
*2 The default value is Any Button. A/V mute is released when any operation is performed on the projector.
Setting Up
31
To Next Page
Loading...
