To continue to move another point, press the [Esc] button to return
to step 2, and then repeat steps 2 and 3.
d
After moving all of the necessary points, press the [Esc] button to
return to step 2, and then press the [Esc] button again. When a
message is displayed, select Yes, and then press the [
] button.
The screen from step 1 is displayed.
e
Select Color Adjustment.
f
Adjust the brightness and tone for the areas that do not overlap
to match the areas that overlap.
(4) Multi-screen
Adjusts the brightness and color balance for projected images that were
corrected using Edge Blending.
Perform this in Multi-screen from the Configuration menu.
Press [Menu] button > Extended > Multi-Projection > Multi-screen
The following screen is displayed.
Adjustment Level: There are five levels from white, gray, and up to black.
Adjust each level individually.
Brightness Correct.: Adjust from black to white for each color tone.
Color Correct. (G/R): Adjust the color tone for green and red.
Projecting Images
67
To Next Page
Loading...
