Submenu Function
Security
Select the security type according to the wireless LAN settings.
When setting security, follow the instructions of your network
administrator.
Passphrase
Enter a passphrase used to connect to the network when Security
is set to WPA2-PSK or WPA/WPA2-PSK.
You can enter at least 8 and up to 63 single-byte alphanumeric
characters.
You can enter up to 32 characters on the Configuration menu.
When entering more than 32 characters, use your Web browser
to enter the text.
s "Changing Settings Using a Web Browser (Epson Web
Control)" p.194
When Connection Mode is set to Quick, the initial passphrase is
set.
Channel
You can select the channels used to connect in Quick mode. If
interference from other signals occurs, use a different channel.
Submenu Function
IP Settings
(This can only be set if Connection Mode is set to Advanced.)
Configure the network.
DHCP: Set to On to configure the network using
DHCP
g
. If this
is set to On, you cannot set any more addresses.
IP Address: You can enter the
IP address
g
assigned to the
projector. You can enter a number from 0 to 255 in each field of
the address. However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Subnet Mask: You can enter the
Subnet Mask
g
for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address: You can enter the IP address for the gateway
for the projector. You can enter a number from 0 to 255 in each
field of the address. However, the following
Gateway Address
g
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
SSID Display
To prevent the SSID from being displayed on the LAN Standby
screen, set this to Off.
IP Address Dis
play
To prevent the IP address from being displayed on the LAN
Standby screen, set this to Off.
Type of security
When the optional wireless LAN unit is attached and being used in
Advanced connection mode, it is strongly recommended that you set
security.
WPA is an encryption standard that improves the security for wireless
networks. The projector supports TKIP and AES encryption methods.
WPA also includes user authentication functions. WPA authentication
provides two methods: using an authentication server, or authenticating
List of Functions
141