Submenu Function
IP Address Dis
play
To prevent the IP address from being displayed on the LAN
Standby screen, set this to Off.
Notifications menu
When this is set, you receive an email notification if a problem or warning
occurs in the projector.
s "Reading error notification mail" p.199
Submenu Function
Mail Notification
Set to On to send an email to the preset addresses when a problem
or warning occurs with a projector.
SMTP Server
You can input the
IP Address
g
for the SMTP server for the
projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Submenu Function
Port Number
You can input the port number for the SMTP server. The default
value is 25. You can input numbers between 1 to 65535.
From
Enter the email address of the sender.
Address 1 Set
ting/Address 2
Setting/Address
3 Setting
Set the destination email addresses for the notification email, and
the notification content. You can register up to three
destinations. You can enter up to 32 single-byte alphanumeric
characters for the email addresses.( " ( ) , : ; < > [ \ ] and spaces
cannot be used.)
SNMP
Set to On to monitor the projector using
SNMP
g
. To monitor
the projector, you need to install the SNMP manager program on
your computer. SNMP should be managed by a network
administrator. The default value is Off.
Trap IP Address
1/Trap IP Ad
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
Community
Name
Set the community name of SNMP. You can enter up to 32 single-
byte alphanumeric characters. (Spaces and symbols other than @
cannot be used.)
List of Functions
143
To Next Page
Loading...
Need help?
General
Weight and Dimensions
