a
• By pressing the [Geometry] button on the remote control or the
[
] button on the control panel, you can perform the selected
adjustment method directly.
• When you want to re-adjust the projection position and so on, if
you want to release the correction status temporarily, set the
Geometry Correction to Off. Even when it is set to Off, the
correction values are saved.
s Settings - Geometry Correction p.131
• You can save the geometry correction settings using Memory in
Geometry Correction, and load them when needed.
s "Memory Function" p.111
H/V-Keystone
This allows you to correct distortion in the horizontal and vertical
directions independently.
Use the following to check the adjustment range for the image.
s
"H/V-Keystone" p.229
a
Press the [Menu] button while projecting.
b
Select Geometry Correction from Settings.
c
Select H/V-Keystone, and then press the [ ] button.
"If this setting is changed, the image may be distorted." is displayed,
press the [
] button again.
d
Use the [ ][ ] buttons to select the correction method, and
then use the [
][ ] buttons to make the corrections.
Adjusting Projected Images
63
To Next Page
Loading...
Need help?
General
Weight and Dimensions
