270
Solutions When the Image Brightness or Colors are Incorrect
If the projected image is too dark or light, or the colors are incorrect, try the following solutions:
• Press the Color Mode button on the remote control to try different color modes for the image and
environment.
• Check your video source settings.
• Adjust the available settings on the Image menu for the current input source, such as Brightness,
Contrast, Tint, Color Saturation, and RGBCMY. RGBCMY should be set by a professional color
calibrator using specialized color calibration tools in a controlled lighting environment.
• Make sure you selected the correct Signal Format or EDID setting in the Signal I/O menu, if available
for your video source.
• Make sure all the cables are securely connected to the projector and your video device. If you
connected long cables, try connecting shorter cables.
• Position the projector close enough to the screen.
• Make sure you have run the Light Source Calibration in the Management menu recently. If using
multiple projectors, perform the calibration on all projectors to ensure a consistent image quality (EB-
L260F/EB-L265F).
Parent topic: Solving Image or Sound Problems
Related references
Input Signal Settings - Signal I/O Menu
Image Quality Settings - Image Menu
Administration Settings - Management Menu
Solutions When an Afterimage Remains On the Projected Image
If you see an afterimage in the projected image, select Refresh Mode > Start in the Management menu.
Parent topic: Solving Image or Sound Problems
Related references
Administration Settings - Management Menu
Solutions to Sound Problems
If there is no sound when you expect it or the volume is too low or high, try the following solutions:
• Press the A/V Mute button on the remote control to resume video and audio if they were temporarily
stopped.
To Next Page
Loading...
Need help?
General