81
4. Select the Projector Control menu and press Enter.
5. Set the Crestron Connected setting to On to allow the projector to be detected.
Note: Enabling Crestron Connected disables the Message Broadcasting feature in the Epson
Projector Management software.
6. When you are finished selecting settings, select Return and press Enter to return to the Network
Settings menu.
7. Select Set, and follow the on-screen instructions to save your settings and exit the menus.
8. Turn off the projector, then turn it on again to enable the setting.
Parent topic: Using Crestron Connected
Related references
Input Signal Settings - Signal I/O Menu
Feature Settings - Operation Menu
Network Settings - Network Menu
To Next Page
Loading...
