208
16. Use the arrow buttons to move the point.
17. To move another point, press the Esc button and repeat the previous two steps.
18. To move another boundary line, press the Esc button repeatedly until you can select a boundary
line.
19. When you are finished, press the Menu button.
Note: Changing the Top Edge, Bottom Edge, Right Edge, or Left Edge settings resets the Black
Level setting to its default value. You can also select the Reset setting from the Black Level menu to
return the Black Level settings to their default value.
Parent topic: Using Multiple Projectors
Related references
Projector Setup Settings - Extended Menu
Matching Tint and Brightness (Screen Matching)
You can adjust the tint and brightness of multiple projectors so they match better. You can also schedule
automatic adjustments to the tint and brightness.
If your projectors are on a network, the brightness and tint for multiple projectors are corrected
automatically based on the darkest projector. The time required for automatic adjustment depends on
projector layout, and can take up to 18 minutes.
The auto adjustment feature is only available under the following conditions:
• When you set the position of each image using the Location Setup setting in the Tiling menu
• When the Color Calibration setting is enabled
• The optional lens ELPLL08 is not installed
To Next Page
Loading...
Need help?
General