Troubleshooting
104
When the Indicators Provide No Help
Check the problem
Check the following table to see if your problem is mentioned, and go to the appropriate page for information
on handling the problem.
Problem Page
Problems relating to im-
ages
No images appear
Projection does not start, the projection area is completely black, or the
projection area is completely blue
p.105
Moving images being projected from a computer are not projected p.105
"Not supported" is displayed
p.106
"No Signal" is displayed
p.106
Images are fuzzy or out of focus p.107
Interference or distortion appears in the images p.107
The image is truncated (large) or small, or only a part of the image is
projected
p.107
Image colors are not right
The whole image appears purplish or greenish, images are black & white,
or colors appear dull
*
p.108
Images appear dark p.108
Projection stops automatically p.108
The LCD Alignment correction is not satisfactory or difficult to achieve p.109
Problems when projection
starts
The projector does not turn on p.109
Problems with the remote
control
The remote control does not respond p.109
Problems with the control
panel
Cannot make settings on the control panel p.110
Problems with 3D images Cannot project correctly in 3D p.110
The 3D image is enlarged and truncated p.111
Problems with HDMI HDMI Link does not function p.111
The device name is not displayed under Device Connections p.111
Problems with WirelessHD Cannot project WirelessHD images p.111
Interference, distortion, or interruption appear in WirelessHD p.112
*
Because color reproduction differs between monitors and computer LCD screens, the image projected by the
projector and the color tones displayed on the monitor may not match, however this is not a fault.
To Next Page
Loading...
Need help?
General
