Useful Functions
67
Connecting with WirelessHD (EH-LS9600W
Only)
Installing the WirelessHD Transmitter
You can use the supplied WirelessHD Transmitter to wirelessly receive image data.
This is useful when the projector cannot be setup near your AV devices as you can connect the devices to the
projector without using cables.
You can use the WirelessHD Transmitter in the following ways.
•
You can connect up to five AV devices at the same time, and switch images using the remote control.
•
As well as the projector, you can connect another monitor device, such as a television, to the Output port, and then
switch the output using the remote control.
•
This allows other monitor devices connected to the Output port to project images from the connected AV device,
even if the projector is off.
•
You can connect smart devices and tablets that support MHL, and then project images from the connected MHL
device. You can also operate MHL devices from the projector's remote control, as well as charge the MHL device.
To Next Page
Loading...
Need help?
General
