Useful Functions
72
Projecting Images
a
Start playback on the AV device, and then turn on the projector and the WirelessHD
Transmitter.
The
t
indicator on the WirelessHD Transmitter turns on.
b
Check the status of the WiHD indicator on the WirelessHD Transmitter.
If the WiHD indicator is on, go to the next step.
If the indicator is off, press the button on the remote control or the WirelessHD Transmitter.
Make sure you point the remote control at the WirelessHD Transmitter when using the
button
on the remote control.
Remote control WirelessHD Transmit-
ter
c
Check the status of the Link indicator on the WirelessHD Transmitter.
If the WirelessHD Transmitter is connected to the projector, the Link indicator flashes and then remains
on.
c
•
If the indicator continues to flash slowly, the WirelessHD Transmitter cannot connect to the
projector and has entered standby status. Make sure the projector has been setup correctly,
such as turning on the power.
•
You can view the signal strength while images are being projected from the WirelessHD settings
menu.
s Settings - WirelessHD - Reception p.91
To Next Page
Loading...
Need help?
General
