Useful Functions
71
Setting the WirelessHD Transmitter
a
Set up the WirelessHD Transmitter
connected to the projector so that
they are facing each other.
s
p.74
c
•
The receiver is located at the front
of the projector and therefore
cannot receive any signals
directly from the rear. Set up the
projector and the WirelessHD
Transmitter so that they are
facing each other.
Also, make sure that the receiver
is not covered.
•
Place the WirelessHD
Transmitter on a level surface
facing towards the projector.
b
Connect the WirelessHD Transmitter
using the supplied AC adapter.
c
Using an HDMI cable, connect the AV
device you want to use to the Input
port on the WirelessHD Transmitter.
You can connect up to five AV devices.
c
•
You can connect another monitor device, such as a television, to the Output port on the WirelessHD
Transmitter. You can switch between output images using the remote control.
s p.75
•
The HDMI5 port of the WirelessHD Transmitter supports the MHL input signal. You can play content
from MHL compatible smart devices or tablets connected with an MHL cable.
•
If the following message is displayed when you connect an MHL device, the device has been connected
to a port other than the HDMI5 port, or the connected device is not compatible with MHL.
"No Signal"
•
You can use the HDMI link function even when using the WirelessHD Transmitter. s p.60
To Next Page
Loading...
Need help?
General
