Configuration Menu
93
Function Menu/Settings Explanation
Operation
Direct Power On On, Off You can set up the projector so that projection
starts as soon as the power cord is plugged in
without any button operations.
Note that when this is set to On, projection starts
if power is restored after a blackout or other
power outage and the power cord is still plugged
into the projector.
Sleep Mode Off, 5min., 10min.,
20min.
If the set time is exceeded and no signal is input,
the projector is automatically turned off and en-
ters standby mode. When set to Off, the projec-
tor never enters sleep mode. When in standby
mode, press the
button on the remote con-
trol or the
button on the control panel to
start projection.
Illumination On, Off
Set this to Off if the light from the indicators on
the control panel bothers you when watching a
movie in a dark room.
Trigger Out 1
Trigger Out 2
Off, Power, Ana-
morphic Wide
Set the Trigger Out function to communicate the
projector's power on status to external devices.
Trigger Out 1 corresponds to the Trigger out 1
port, and Trigger Out 2 corresponds to the Trig-
ger out 2 port.
When set to Off, no voltage is output from the
Trigger out 1/Trigger out 2 ports.
When set to Power, voltage is output from the
Trigger out 1/Trigger out 2 ports when the pro-
jector is on.
For Anamorphic Wide, when the projector is on
and Aspect is set to Anamorphic Wide or Horiz.
Squeeze, voltage is output from the Trigger out
1/Trigger out 2 ports.
If you change this setting, the new setting will
take effect the next time you turn the projector
on.
High Altitude Mode On, Off
Set this to On if you are using the projector above
an altitude of 1500 meters.
Lens Adjustment
Mode
1, 2, 3 Set the amount of lens movement for the focus,
zoom, and lens shift adjustments when pressing
the
buttons once.
The default value is 2. Select 1 to make the
amount of movement smaller, and select 3 to
make the amount of movement larger.
To Next Page
Loading...
Need help?
General
