EasyManuals Logo

Epson EH-TW5700 User Manual

Epson EH-TW5700
93 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Preparing
15
Various Setting Methods
Warning
A special method of installation is required when suspending the projector from a ceiling (ceiling mount). If
it is not installed correctly, it could fall, causing an accident and injury.
Failure to install the ceiling mount and projector may cause the projector to fall. Be sure to use the specific
Epson mount that supports this projector, and secure it to all of the projector's ceiling mount fixing points.
Also, make sure you secure the projector and the mount using wire and so on that is strong enough to hold
their weight.
Do not apply adhesives, oils, lubricants, detergents, solvents, chemicals, and so on to the projector case or
the mount. Otherwise, the projector case may deteriorate or be damaged causing the projector to fall from
the mount.
Do not set up the projector in locations exposed to humidity or dust, or in locations exposed to oil smoke or
steam such as on a kitchen counter, in the kitchen, or near a humidifier. Doing so could cause fire or electric
shock. In addition, the oil content could cause the projector’s outer case to deteriorate and could cause the
projector to fall off from the ceiling where it is suspended.
Examples of environments that could cause the projector to fall due to case deterioration/damage
Locations subject to oily smoke, such as factories, restaurant kitchens, or home kitchens
Locations containing volatile solvents or chemicals, such as factories or laboratories
Locations where oil, detergents, chemicals, and so on could adhere to the projector such as factories, restaurant
kitchens, or home kitchens
Locations in which aroma oils are often used, such as relaxation rooms
Locations near devices that produce excessive smoke, airborne oil particles, or foam at events
Do not install in locations where salt damage could occur, or in locations subject to corrosive gas such as
sulphuric gas from hot springs. Otherwise, corrosion could cause the projector to fall. It could also cause the
projector to malfunction.
Do not install it on an unstable shelf or in a place out of load range. Otherwise, it could fall or topple causing
an accident and injury.
When installing the projector in a high position such as on a shelf, take measures against falling by using
wires or belts to ensure safety in an emergency such as an earthquake, and to prevent accidents. If it is not
installed correctly, it could fall causing an accident and injury.
Do not block the air intake vent and air exhaust vent of the projector. Blocking its air intake vent and air
exhaust vent may trap heat inside causing fire.
Do not use or store the projector in dusty or dirty locations. Doing so could cause the quality of the projected
image to deteriorate, or the air filter to become clogged with dust which can cause malfunctions or a fire to
occur.
Attention
Do not project under the following conditions. Doing so could cause a malfunction or accident to occur.
Do not project by standing the projector vertically
Do not project from above or below
Do not project by tilting to the left or right
Clean the air filter once every three months. Clean it more often if the environment is particularly dusty.
s p.69

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson EH-TW5700 and is the answer not in the manual?

Epson EH-TW5700 Specifications

General IconGeneral
Heat dissipation1009.8 BTU/h
Number of colors1.073 billion colors
Native aspect ratio16:9
Projection distance2.71 - 2.61 m
Projection technology3LCD
Contrast ratio (typical)35000:1
Screen size compatibility34 - 332 \
Projector native resolution1080p (1920x1080)
Keystone correction, horizontal-30 - 30 °
PlacementCeiling
Product typeStandard throw projector
Product colorWhite
Market positioning-
Lamp typeUHE
Lamp power200 W
Light source typeLamp
Service life of light source4500 h
Service life of light source (economic mode)7500 h
FocusManual
Focal length range16.9 - 20.28 mm
Power sourceAC
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (standby)0.3 W
Power consumption (typical)297 W
Video color modesBright cinema, Cinema, Dynamic, Natural
DVI portNo
HDMI version1.4
HDMI connector typeFull-size
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Weight and Dimensions IconWeight and Dimensions
Depth315 mm
Width309 mm
Height122 mm
Weight3600 g

Related product manuals