Preparing
21
Removing the Interface Cover
The interface cover is attached to the connector section on the rear of EH-TW9100W/EH-TW8100W. Remove
this cover when using a cable to connect a device.
There are gaps at the bottom of the interface cover that allows you to pull the cover forward and lift it from
the grooves at the top.
c
•
When reattaching, first insert the protruding sections into the grooves at the top.
•
Make sure you store the interface cover safely, as you need this when transporting the projector.
Connecting an HDMI Cable Clamp
If the HDMI cable is thick and hangs down, make sure you secure it to the cable holder with an HDMI clamp
so that the cable's weight does not disconnect it from the port.
c
If the cable cover is attached, you do not need to attach a cable clamp because the cable is secured
by the cover.
To Next Page
Loading...
