Configuration Menu
74
Function Menu/Settings Explanation
Lock Setting
Child Lock On, Off
This locks the
button on the
projector's control panel to prevent
children from turning on the pro-
jector by accident. You can turn on
the power when locked by holding
down the
button for approxi-
mately three seconds. You can still
turn off the device using the
button, or perform operations with
the remote control as usual.
If changed, this setting is enabled
after you power off the projector
and the cool-down process is com-
plete.
Note that even if Child Lock is set to
On, the projector still turns on and
starts projecting when the main
power switch is turned on if Direct
Power On is set to On.
Control Panel Lock On, Off
When set to On, all buttons on the
control panel except for the
button are disabled. is dis-
played on the screen if any buttons
are pressed. To unlock, press and
hold the
button on the con-
trol panel for at least 7 seconds.
If changed, this setting is enabled
once you close the configuration
menu.
Projection
Front, Front/Ceiling, Rear, Rear/Ceiling Change this setting depending on
how the projector is installed.
•
Front: Select if you are projecting
in front of the screen.
•
Front/Ceiling: Select if you are
projecting in front of the screen
suspended from the ceiling.
•
Rear: Select if you are projecting to
a rear screen from the back.
•
Rear/Ceiling: Select if you are pro-
jecting to a rear screen from the
back when the projector is suspen-
ded from the ceiling.
User Button
2D-to-3D Conversion, 3D Format
*
, 3D Depth, 3D Bright-
ness, Inverse 3D Glasses, Brightness Control, About
Select the 3D Setup function you
want to assign to the
button
on the remote control. By pressing
the
button, the assigned
menu item selection/adjustment
screen is displayed, allowing you to
make one-touch settings/adjust-
ments.
Split Screen
- Starts split screen display. s p.65
To Next Page
Loading...
Need help?
General
Weight and Dimensions
