3. Close the cover. Repeat steps 1 to 3 for all the films you want to scan.
4. Place the holder on the scanner glass and align it with the notch on the transparency guide, as shown below.
Non-standard film sizes
Place the film directly on the scanner glass, making sure the glossy (smooth) side of the film is facing down.
If the document mat is installed in the Transparency Unit, remove it. Close the Transparency Unit.
Note:
❏ An area 0.67 ± .02 in. (17.0 ± 0.5 mm) from the horizontal and 0.8 ± .02 in (2.0 ±0.5 mm) from the vertical edges
of the scanner glass cannot be scanned.
❏ When you place the film directly on the scanner glass, make sure you set the focus position to 0.0 in Epson Scan 2.
Using the Transparency Unit
>
Setting and Placing Films
>
Non-standard film sizes
47
To Next Page
Loading...
