Getting Started 13
Turning the Scanner On and Off
Follow these steps to turn on the scanner:
1. Pull up the transportation lock on the back of
the scanner to the Unlock position.
2. Before you plug in the scanner, make sure it is
turned off (the . Power button is not pushed
in).
3. Plug one end of the scanner’s power cord into
the AC inlet at the back of the scanner, and the
other end into a grounded electrical outlet.
4. Press the . Power button on the front
of the scanner to turn it on.
The green Ready light starts flashing.
5. Wait until the Ready light stops
flashing, then press the . Power
button again to turn it off.
Now see the next section to connect the
scanner to your computer, and then install
the software as described on page 16.
Transportation lock
Ready light
. Power button
To Next Page
Loading...
