Using Optional Equipment 49
2. Remove the two screws securing the shield
plate to the scanner’s optional interface slot.
Then remove the plate.
Put the screws and shield plate in a safe place
in case you want to reinstall the shield plate
later.
3. Turn the card over so that the
component side is facing down, and
insert it in the optional interface slot.
4. Push gently until the card is firmly
seated.
5. Tighten the retaining screws and
reconnect the scanner’s cables.
6. Plug one end of the IEEE 1394 cable
into the IEEE 1394 port on the card,
and the other end into an IEEE 1394
(FireWire) port on your computer.
To Next Page
Loading...
