Using Optional Equipment 51
6. To initialize the card, turn on the scanner while holding down the Reset button
on the card for about 10 seconds. The red and green lights on the card turn on.
7. Wait until the red and green lights turn off, then turn off the scanner.
8. Connect an Ethernet cable to the connector on the card. Make sure you use a
Category 5 shielded twisted-pair cable.
9. Connect the other end of the cable to your network hub.
For information on configuring the scanner for your network, see the Epson Network
Image Express Card User’s Guide that came with the card.
Reset button
Lights
To Next Page
Loading...
