Pull Tractor
The optional pull tractor (C80032
✽
) provides easy continuous
paper handling. (The asterisk(
✽
) is a substitute for the last digit of
the product number, which varies by country.) You can use the
optional pull tractor unit as a front push tractor.
The pull tractor is especially useful with continuous multipart
forms. It may be used in combination with the rear push tractor.
Also, two pull tractors may be used in a front push/pull
combination. See Chapter 2 for instructions.
Note:
You cannot remove the rear push tractor.
Roll Paper Holder
The optional roll paper holder (#8310) allows you to use your
printer with 8.5-inch roll paper like that used with telex machines.
Before you use roll paper, set the default setting of roll paper to on.
See “Using the Default Setting Mode” in Chapter 3 for details.
To use the roll paper holder, follow the steps below.
Note:
This option is not available in all countries.
1. Turn off the printer and make sure the paper release lever is at
the single-sheet position.
R
Sunflower-P
Rev.c A5
size Chapter 4
01/09/96 pass 1
Using Printer Options
4-9
To Next Page
Loading...
