This chapter describes how to use optional equipment with your
printer, including cut-sheet feeders, a pull tractor, a roll paper
holder, and interface cards.
Cut-Sheet Feeders
Two cut-sheet feeders are available for use with your printer.
Printer model High capacity (Bin 1) SSecond bin (Bin 2)
LQ-2070 C80673✽ C80674✽
The asterisk (✽) is a substitute for the last digit, which varies by country.
Contact your local EPSON dealer for the part number in your country.
By connecting both cut-sheet feeders, you can operate them as a
double bin cut-sheet feeder. This allows you to load two different
types of paper. See “Installing the double bin cut-sheet feeder” on
page 4-6.
Before you install your cut-sheet feeder, assemble it by following
the instructions in the manual that comes with it.
Note:
The second bin cut-sheet feeder can only be used in combination with the
high capacity cut-sheet feeder.
Installing the high capacity cut-sheet feeder
1. Make sure the printer is turned off.
2. Remove the paper guide and the printer cover.
L
Sunflower-P
Rev.c A5
size Chapter 4
01/09/96 pass 1
4-2
Using Printer Options
To Next Page
Loading...
