Running the Self Test
You can run a self test on the printer in letter quality or draft
mode, with either continuous paper or single sheets. You can load
the paper from the rear, front, top, or bottom. The following steps
describe how to run the test on single-sheet paper, loaded from the
top. See Chapter 2 for more information on paper handling.
The printer prints the self test in the currently selected font.
1. Make sure the printer is turned off and the paper path guide is
open.
2. Move the paper release lever to the single-sheet position.
3. For a letter quality test, hold down the
Load/Eject
button
while you turn on the printer. For a draft printing test, hold
down the
LF/FF
button while you turn on the printer.
1-12
R
Sunflower-P
Rev.c
A5 size Chapter 1
01/09/96 pass 3
Setting Up the Printer
1-11
To Next Page
Loading...
