5. Replace the paper guide.
You are now ready to load continuous paper with the pull tractor.
See “Loading paper with the pull tractor” on page 2-24 or
“Loading paper with the push/pull tractor combination” on page
2-27 for more details.
Removing the tractor from the pull position
If you want to use the tractor in another position, follow the
directions below to remove it. Then see the appropriate section for
installation instructions.
1. Make sure the printer is turned off.
2. Remove any paper that is in the feed path.
3. Remove the printer cover and paper guide.
4. Hold down the tractor’s lock tabs, tilt it forward, and lift it off the
printer.
2-19n
R
Sunflower-P
Rev.c
A5 size Chapter 2
01/19/96 pass 2
Paper Handling
2-19
To Next Page
Loading...
