4. Hold the cartridge so that the ribbon-tightening knob is facing
up and is on the left. Place the bottom edge of the cartridge
into the printer so that the notch on each end of the cartridge
fits over the small peg on each side of the printer.
5. Lay the cartridge flat and press gently until it clicks into place
on both ends.
6. Lift the ribbon guide and insert it firmly over the metal pins
behind the print head. Press down on the guide until it clicks
into place. Make sure the ribbon is not twisted or creased and
that it is in place behind the print head. Turn the
ribbon-tightening knob to remove any slack in the ribbon.
1-5
1-6
R
Sunflower-P
Rev.c
A5 size Chapter 1
01/09/96 pass 3
Setting Up the Printer
1-7
To Next Page
Loading...
