6. Lock the sprocket in place. Then slide the right sprocket to match
the width of your paper, but do not lock it. Move the paper
support midway between the two sprocket units.
7. Make sure your paper has a clean, straight edge. Then open the
sprocket covers and fit the holes of the paper, printable side
up, over the tractor pins.
8. Close the sprocket covers.
9. Slide the right sprocket to remove any slack in the paper; then
lock it in place.
10. Attach the front paper guide over the paper as shown below.
2-23
2-24
R
Sunflower-P
Rev.c
A5 size Chapter 2
01/19/96 pass 2
Paper Handling
2-23
To Next Page
Loading...
