To load paper in the tractors, follow these steps:
1. Make sure the tractors are in the front or rear push/pull tractor
position. Also, make sure the paper release lever is set to either
the front push or rear push tractor position.
2. Load paper in the front or rear push tractor as described in the
appropriate section earlier in this chapter.
3. Push the
LF/FF
button to advance the paper to the next page.
4. Load paper in the pull tractor as described in the previous
section.
5. Move the paper release lever to the pull tractor position, and use
Micro Adjust (described in the next chapter) to remove any
slack in the paper.
2-36n
L
Sunflower-P
Rev.c
A5 size Chapter 2
01/19/96 pass 2
2-28
Paper Handling
To Next Page
Loading...
