5
Changing Printer Settings From the Printer’s Control Panel
5-5
R4C3730
Rev. C
A5 size CHAP5.FM
8/23/99 Pass 0
R
Proof Sign-off:
<Crestec> _______
<Kimura> _______
<Crestec> _______
Page length for front tractor
This setting allows you to set the page length (in in.) for
continuous paper loaded on the front push tractor.
Page length for rear tractor
This setting allows you to set the page length (in in.) for
continuous paper loaded on the rear push tractor.
Skip over perforation
This setting takes effect only when you are using continuous
paper. When you select
On
, the printer provides a one-in.
(25.4 mm) margin between the last line printed on one page and
the first line printed on the next page. Because most application
programs override margin settings made from the control panel,
you should use this setting only if you cannot set your top and
bottom margins using your application.
International character set
for Italic table
Italic U.S.A, Italic France, Italic
Germany, Italic U.K., Italic
Denmark1, Italic Sweden, Italic
Italy, Italic Spain1
0 slash On, Off
High speed draft Off, On
Input buffer On, Off
Buzzer On, Off
Auto CR (IBM 2391 Plus)** On, Off
A.G.M. (IBM 2391 Plus) ** On, Off
Font OCR-B, Orator, Orator-S, Script C,
Roman T, Sans Serif H
Roll paper On, Off
* The options available vary depending on the country.
**These settings take effect only when IBM 2391 Plus emulation is
selected.
Settings Options
To Next Page
Loading...
