3-6
Printing on Single Sheets
R4C3730
Rev. C
A5 size CHAP3.FM
8/23/99 Pass 0
L
Proof Sign-off:
<Crestec> _______
<Kimura> _______
<Crestec> _______
Loading envelopes
You can load envelopes only in the top paper slot as described in
“Loading Single Sheets in the Top Paper Slot” on page 3-8. Also
follow these guidelines:
❏ Load envelopes one at a time in the top slot, with the flap edge
first and the flap side up.
❏ Set the paper thickness lever (located under the printer cover)
to position 2 to 6 to match the thickness of the envelope.
❏ Before printing, turn on the card mode by pressing the
Tear Off/Bin
button until both
Tear Off/Bin
lights are on.
After you finish printing on envelopes, press the
Tear Off/
Bin
button once to exit the card mode. (Bin 1 is selected.)
❏ Do not use envelopes that are curled or folded. Also avoid
using envelopes that are too thin; they may curl during
printing and become jammed.
❏ If you use No. 6 envelopes, align the left edge of the envelope
with the arrow mark on the printer.
❏ Use envelopes only under normal temperature and humidity
conditions, as follows:
Temperature15 to 25°C (59 to 77°F)
Humidity 30 to 60% RH
flap side up, printable
side down
New01.eps
To Next Page
Loading...
