1-14
Setting Up the Printer
R4C3730
Rev. C
A5 size CHAP1.FM
8/23/99 Pass 0
L
Proof Sign-off:
<Crestec> _______
<Kimura> _______
<Crestec> _______
2. Plug the cable connector securely into the printer’s interface
connector, and squeeze the wire clips together until they lock
in place on both sides of the connector.
3. If your cable has a ground wire, connect it to the printer’s
ground connector as shown below.
4. Plug the other end of the cable into the computer. (If the cable
has a ground wire at the computer end, attach it to the ground
connector at the back of the computer.)
After you connect the printer to your computer, install the printer
software as described in the next section.
1-16.eps
To Next Page
Loading...
