2-8
Printing on Continuous Paper
R4C3730
Rev. C
A5 size Chap2.fm
8/23/99 Pass 0
L
Proof Sign-off:
<Crestec> _______
<Kimura> _______
<Crestec> _______
8. Attach the paper guide as described on page 1-11.
9. Slide the edge guides to the middle of the paper guide. Then
close the paper guide cover.
Note:
Always close the printer cover before printing. The printer does not
print when the cover is open.
10. Make sure the printer is on. You may need to check and
change the printer driver settings as described in Chapter 4.
When the printer receives data, it automatically loads the
paper and starts printing. The printed pages are fed over the
paper guide toward the back of the printer.
11. After you finish printing, follow the steps in the next section
to tear off your printed document. If the first printed line on
your page appears too high or low, you can fix this using the
micro adjust feature. See “Adjusting the Top-of-Form
Position” on page 2-37.
c
Caution:
Never use the knob to adjust the top-of-form position; this may
damage the printer or cause it to lose the top-of-form position.
2-10.eps
To Next Page
Loading...
