2
Printing on Continuous Paper
2-29
R4C3730
Rev. C
A5 size Chap2.fm
8/23/99 Pass 0
R
Proof Sign-off:
<Crestec> _______
<Kimura> _______
<Crestec> _______
c
Caution
❏
Never use the knob to remove slack in the paper or to
adjust the top-of-form position; this may damage the
printer or cause it to lose the top-of-form position.
❏
Always remove any slack from the paper; otherwise print
quality may be reduced.
9. Attach the paper guide. Then slide the edge guides to the
middle of the paper guide.
10. Attach the printer cover and close the paper guide cover.
Note:
Always close the printer cover before printing.
11. You may need to check and change the printer driver settings
as described in Chapter 4. Then send a print job to the printer.
The printer starts printing from the current position without
advancing the paper. The printed pages are fed over the paper
guide toward the back of the printer.
12. After you finish printing, open the paper guide cover; then
tear off the printed document at the perforation nearest the
paper exit slot.
To remove the paper from the tractors, follow the steps under
“Removing paper from the pull tractor” on page 2-27.
G05-1.eps
To Next Page
Loading...
