Epson LQ-2080 - Page 98

3-12
Printing on Single Sheets
R4C3730
Rev. C
A5 size CHAP3.FM
8/23/99 Pass 0
L
Proof Sign-off:
<Crestec> _______
<Kimura> _______
<Crestec> _______
6. Insert a sheet of paper printable side up between the edge
guides until it meets resistance. The printer feeds the paper
automatically and is ready to print.
Note:
Always close the printer cover before printing.
7. You may need to check and change the printer driver settings
as described in Chapter 4. Then send a print job to the printer.
When the printer receives data, it prints the page and ejects it onto
the paper guide on top of the printer. To continue printing your
document, remove the printed page and insert a new sheet of
paper in the front paper guide. If you need to eject a sheet, press
the
Load/Eject
button.
If the first printed line on your page appears too high or low, you
can fix this using the micro adjust feature. See “Adjusting the
Top-of-Form Position” on page 2-37.
c
Caution:
Never use the knob to adjust the top-of-form position or eject a
sheet when the printer is on; this may damage the printer or cause
it to lose the top-of-form position.
2-12.eps