Projecting From an iPod, iPhone, or iPad 19
Projecting From an iPod, iPhone,
or iPad
The projector features a dock that allows you to connect an iPod, iPhone, or iPad and charge
it while you play back media stored on the device.
Note: The term “iPod” is used in this manual to describe an iPod, iPhone, or iPad unless
otherwise noted.
Tip: When your iPod is connected to the projector, it charges whenever the projector is on,
including when the projector is in standby mode.
Connecting an iPod or iPhone
1. Remove any protective case from your device.
2. Eject the dock by pressing on it until it clicks, then release it. The dock slides out.
3. Connect the device by aligning it with the dock connector and gently pushing it straight
down as shown.
Caution: To prevent damage, do not apply too much pressure when connecting your device.
To Next Page
Loading...
