66 Problem Solving
Problem Solving
This section explains how to interpret the projector’s lights, solve problems with the picture
and remote control, and contact technical support.
What To Do When the Lights Come On
or Flash
The lights on top of the projector indicate the
projector’s status and let you know when a problem
occurs.
If the projector isn’t working correctly, first press the
P power button, let the projector cool down, and
unplug the power cord. Then plug the power cord back
in and turn on the projector. If this doesn’t solve the
problem, check the status lights on top of the projector.
Light status during normal operation
Light status Cause and solution
All lights are off. The projector is turned off. If necessary, connect the power
cord. Also check to see if the
Illumination setting is to Off.
See page 50.
Power button is on. The projector is in standby mode. Unplug the projector to turn
it off, or press the
Ppower button to turn it on.
Power button is on and
power light flashes.
The projector is warming up. Wait for the picture to appear.
or the projector is cooling down. Wait until the light stops
flashing and turns off. The projector is now in standby mode.
Do not unplug the power cable while the projector is cooling
down. This may reduce the life span of the lamp.
Status
lights
Status lights
To Next Page
Loading...
