30 Connecting Other Devices
Connecting a Microphone
Audio from a microphone can be output from the projector’s speakers. To use the
microphone, plug it into the
Mic port on the side of the projector.
Note: Set Plug-in Power to On when using a microphone or condenser microphone that
supports plug-in power.
Lowering the value of the Mic Input Level
makes the audio input level from other devices higher.
Increasing the value of the Mic Input Level makes it lower.
Connecting a USB Storage Device
You can project the images stored on a USB storage device, such as a USB flash drive or
digital camera, by connecting it to the projector’s USB (
TypeA) port (MG-850HD only).
Note: This feature is only available on the MegaPlex MG-850HD.
To connect a digital camera, hard drive, or Epson DC-06 document camera, use the USB
cable that came with the device.
Tip: For best results, use a hard drive that meets the following requirements:
■ USB Mass Storage Class-compatible
■ Formatted in FAT or FAT32
■ Self-powered with its own AC power supply
USB TypeA
To Next Page
Loading...
