80 Notices
Notices
Important Safety Information
Follow these safety instructions when setting up and using the projector:
■ Never look into the projector lens when the lamp is turned on; the bright light can damage your eyes. Never
let children look into the lens when it is on.
■ Never open any cover on the projector, except the lamp and filter covers. Dangerous electrical voltages inside
the projector can severely injure you.
■ Except as specifically explained in this User’s Guide, do not attempt to service this product yourself. Refer all
servicing to qualified service personnel.
■ The projector’s accessories come packaged in plastic bags. Keep plastic bags away from small children to avoid
any risk of suffocation.
■ Don’t place the projector on an unstable cart, stand, or table. Also, don’t use the projector near water or
sources of heat.
■ Use the type of power source indicated on the projector. If you’re not sure of the power available, consult
your dealer or power company.
■ Place the projector near a wall outlet where the plug can be easily unplugged.
■ Don’t insert the plug into an outlet with dust present, and insert the plug firmly into the outlet. Failure to do
so could result in sparks or fire.
■ Don’t overload wall outlets, extension cords, or integral convenience receptacles. This can cause fire or
electric shock.
■ Don’t block the slots and openings in the projector case. They provide ventilation and prevent the projector
from overheating. Don’t operate the projector on a sofa, rug, or other soft surface, or in a closed-in cabinet
unless proper ventilation is provided.
■ Never push objects through the cabinet slots or spill liquid into the projector.
■ Unplug the projector from the wall outlet and refer servicing to qualified service personnel under the
following conditions: when the power cord or plug is damaged or frayed; if liquid has been spilled into the
projector, or if it has been exposed to rain or water; if it doesn’t operate normally when you follow the
operating instructions, or if it exhibits a distinct change in performance, indicating a need for service; if it has
been dropped or the housing has been damaged.
■ Don’t place the projector where the cord can be walked on. This may result in fraying or damage to the plug.
■ Unplug the projector from the wall outlet before cleaning. Use a damp cloth for cleaning. Do not use liquid
or aerosol cleaners.
■ The lamp(s) in this product contain mercury. Please consult your state and local regulations regarding
disposal or recycling. Do not put in the trash.
■ Allow the lamp to cool for one hour before replacing it.
To Next Page
Loading...
