PictureMate PM 240 / PM 280 Preparing to Print 23
Choosing a Photo Source
If two or more sources such as a memory card and
external device are available, you need to set the
source of the photos by following this procedure before
you start printing photos.
1. Press the Menu button.
2. Press the d button to highlight the Select menu,
then press the right soft key.
3. Press the d button to highlight Select Source
then press the right soft key.
4. Press the d button to choose from Memory
Card, External Device, or CD (PictureMate PM
280 only), then press the right soft key.
Inserting a Memory Card
1. Press the d On button to turn on PictureMate.
2. Make sure the memory card light is off and no
cards are in both slots. Then insert a memory card
into the correct slot, as shown in the illustration.
c
Caution:
❏ Insert just one card at a time.
❏ Load your memory card only as shown
in the following table or you may
damage your printer, memory card, or
both. If you insert a card incorrectly,
you see an error message on the LCD
screen. Remove the memory card and
insert it correctly.
❏ Do not press the button on the right
side of the lower card slot when you
insert a CompactFlash card or you
cannot remove the card.
❏ If the CompactFlash card is not
recognized, remove the card and
insert it again.
To Next Page
Loading...
