PictureMate PM 240 / PM 280 Printing From an External Device 43
Printing From a PictBridge-Enabled
Camera
You can connect your PictBridge- or USB DP-enabled
digital camera to the back of PictureMate and use the
camera to control printing. (See your digital camera's
documentation to see if it supports the PictBridge
standard or USB DP.)
1. Make sure PictureMate is on.
2. Make sure there are no memory cards in
PictureMate’s slots. The memory card light should
be off.
Note:
If a memory card is inserted, the printer will read
photos from the card, not from a camera.
3. Press the Menu button.
4. Press the d button to highlight the Setup menu,
then press the right soft key.
5. Press the d button to highlight Direct Print
Settings, then press the right soft key.
6. Follow the on-screen instructions to make the
Direct Print Settings.
7. Connect your camera’s USB cable to your camera
and the EXT. I/F port on the back of PictureMate.
To Next Page
Loading...
