Epson PowerLite 119W User Manual

55
7. Select the Wired LAN menu and press Enter.
8. If necessary, select IP Settings and press Enter.
9. Select your IP Settings as necessary:
• If your network assigns addresses automatically, turn on the DHCP setting.
• If you must set addresses manually, turn off DHCP and enter the projector's IP Address, Subnet
Mask, and Gateway Address as needed.
Note: To highlight the numbers you want from the displayed keyboard, press the arrow buttons on
the remote control. To select a highlighted number, press Enter. Or, press and hold the Num button
on the remote control while entering the desired numbers.
10. To prevent display of the IP address on the standby screen, turn off IP Address Display.
11. To connect the projector to the network using IPv6, select On as the IPv6 Settings option. Then
select the Auto Configuration and Use Temporary Address settings as necessary.
12. When you finish selecting settings, select Complete and follow the on-screen instructions to save
your settings and exit the menus.
Parent topic: Wired Network Projection

Epson PowerLite 119W Specifications

General

Resolution	WXGA (1280 x 800)
Contrast Ratio	16, 000:1
Weight	5.5 lbs (2.5 kg)
Keystone Correction	Vertical: ±30 degrees, Horizontal: ±30 degrees
Display Technology	3LCD
Brightness	4000 lumens
Lamp Life	Up to 12, 000 hours (ECO Mode)
Connectivity	HDMI, VGA, USB
Throw Ratio	1.30 – 1.56
Speakers	16 W (Mono)
Projection Size	30 inches - 300 inches
Input Ports	HDMI, VGA, USB
Output Ports	VGA
Power Consumption	310W (Normal), 225W (ECO)