Specifying Either an IP Address or Projector Name and Performing a Search (Advanced Connection Mode Only)
34
Specifying Either an IP Address or Projector Name and Performing a Search (Advanced Connection
Mode Only)
In the following explanations, unless otherwise noted, Windows screen
shots are used.
You see the similar screens even when using Macintosh.
Procedure
A Click "Manual search" on the EMP NS Connection projector
selection screen.
B Enter the IP Address or the Projector Name for the projector
you want to connect to, and click "OK".
The search results are displayed on the EMP NS Connection pro-
jector selection screen.
Provided the target projector has been identified, select that projec-
tor, and then click Connect to establish a connection.
When you will always be using that projector, save the search as a
Profile, so that you do not have to specify the relevant details every
time you perform a search. s p.35
q
When you use Manual search in Quick Connection Mode, you can specify
the SSID. When there are a lot of projectors you can narrow the search field
by using SSID.
To Next Page
Loading...
