Troubleshooting
61
Cannot connect in Advanced Connection Mode or Wired
LAN connection
The Slide show cannot be displayed on the desired display
when the multi-screen display function is being executed.
Is the network cable connected correctly?
For Wired LAN
Check that the network cable is connected correctly. Reconnect it if it is not connected or not
connected properly.
Check Remedy
Check Remedy
Are the SSID settings for the computer, access point, and
projector different?
Set the computer, the access point, and the projector to the same SSID. See your User’s Guide for more
information.
Are the WEP keys set properly? When selecting WEP from Security, set the access point, the computer, and the projector to the same
WEP key. See your User’s Guide for more information.
Are the connection denial functions, such as MAC Address
restrictions and port restrictions, set correctly at the
access point?
Set the projector to allow connections from the access point.
Are the IP address, the Subnet Mask, and the Gateway
Address for the access point and the projector set
correctly?
When not using a DHCP, adjust each setting. See your User’s Guide for more information.
Are the access point and the projector's subnet different? Select Manual search from EMP NS Connection, specify the IP address, and connect.
s p.34
Check Remedy
Are you using PowerPoint 2002 or an earlier version?
For Windows
To set and use two or more virtual displays, use PowerPoint 2003 or later, or limit the number of
virtual displays to one before displaying the Slide show.
To Next Page
Loading...
Need help?
General