Epson PowerLite E20 User Manual

126
Entering a Password to Use the Projector
If a password is set up and a Power On Protection password is enabled, you see a prompt to enter a
password whenever you turn on the projector.
You must enter the correct password to use the projector.
1. Press and hold down the Num button on the remote control while you enter the password using the
numeric buttons.
Note: The default password is 0000.
The password screen closes.
2. If the password is incorrect, the following may happen:
• You see a "wrong password" message and a prompt to try again. Enter the correct password to
proceed.

Epson PowerLite E20 Specifications

General

Contrast Ratio	15, 000:1
Projection Technology	3LCD
Aspect Ratio	4:3
Keystone Correction	Vertical: ±30 degrees
Speaker	2W Mono
Color Reproduction	Up to 1.07 billion colors
Lamp Life	12000 hours (Eco mode)
Zoom Ratio	1.35x
Inputs	HDMI, VGA, Composite Video, USB Type-A, USB Type-B
Projection Size	30 inches - 350 inches
Brightness	3400 Lumens (Color), 3400 Lumens (White)
Resolution	XGA (1024 x 768)