Epson PowerLite E20 User Manual

172
Related references
Projector Light Status
Cleaning the Air Filter and Vents
Clean the projector's air filter or vents if they get dusty, or if you see a message telling you to clean them.
1. Turn off the projector and unplug the power cord.
2. Gently remove the dust using a small vacuum designed for computers or a very soft brush (such as
a paintbrush).
Note: You can remove the air filter so you can clean both sides of it. Do not rinse the air filter in
water or use any detergent or solvent to clean it.
Caution: Do not use canned air. The gases may leave a flammable residue or push dust and debris
into the projector's optics or other sensitive areas.
3. If dust is difficult to remove or the air filter is damaged, replace the air filter.
Parent topic: Air Filter and Vent Maintenance
Replacing the Air Filter
You need to replace the air filter in the following situations:
• After cleaning the air filter, you see a message telling you to clean or replace it
• The air filter is torn or damaged
You can replace the air filter while the projector is mounted to the ceiling or placed on a table.
1. Turn off the projector and unplug the power cord.

Epson PowerLite E20 Specifications

General

Contrast Ratio	15, 000:1
Projection Technology	3LCD
Aspect Ratio	4:3
Keystone Correction	Vertical: ±30 degrees
Speaker	2W Mono
Color Reproduction	Up to 1.07 billion colors
Lamp Life	12000 hours (Eco mode)
Zoom Ratio	1.35x
Inputs	HDMI, VGA, Composite Video, USB Type-A, USB Type-B
Projection Size	30 inches - 350 inches
Brightness	3400 Lumens (Color), 3400 Lumens (White)
Resolution	XGA (1024 x 768)