56
Wireless Network Projection
You can project over a wireless network (not supported on PowerLite E20). To do this, you must set up
your projector and computer for wireless projection.
Note: The Epson 802.11b/g/n wireless LAN module is optional for PowerLite
X49/W49/118/119W/982W. The wireless module is built-in for PowerLite 992F/1288.
There are two ways to connect to your projector wirelessly:
• Creating a Quick Wireless Connection USB Key (Windows only) using the Epson iProjection software
• Configuring the connection manually using the projector's Network menus
After connecting and setting up the projector, install the projector software. You may need to install it
from a software CD, if included, or download the software and manuals as necessary.
Note: If your projector is connected via a LAN cable to a network that includes a wireless access point,
you can connect to the projector wirelessly through the access point using the Epson network software.
Installing the Wireless LAN Module
Using a QR Code to Connect a Mobile Device
Using Quick Wireless Connection (Windows)
Selecting Wireless Network Settings Manually
Selecting Wireless Network Settings in Windows
Selecting Wireless Network Settings on Mac
Setting Up Wireless Network Security
Parent topic: Using the Projector on a Network
Related references
Additional Projector Software and Manuals
Optional Equipment and Replacement Parts
Installing the Wireless LAN Module
To use the projector over a wireless network, install the Epson 802.11b/g/n wireless LAN module in the
projector (PowerLite X49/W49/118/119W/982W). Do not install any other type of wireless module.
Note: The wireless LAN module is not included with your projector and is optional.
To Next Page
Loading...
Need help?
General
