Epson PowerLite E20 User Manual

55
7. Select the Wired LAN menu and press Enter.
8. If necessary, select IP Settings and press Enter.
9. Select your IP Settings as necessary:
• If your network assigns addresses automatically, turn on the DHCP setting.
• If you must set addresses manually, turn off DHCP and enter the projector's IP Address, Subnet
Mask, and Gateway Address as needed.
Note: To highlight the numbers you want from the displayed keyboard, press the arrow buttons on
the remote control. To select a highlighted number, press Enter. Or, press and hold the Num button
on the remote control while entering the desired numbers.
10. To prevent display of the IP address on the standby screen, turn off IP Address Display.
11. To connect the projector to the network using IPv6, select On as the IPv6 Settings option. Then
select the Auto Configuration and Use Temporary Address settings as necessary.
12. When you finish selecting settings, select Complete and follow the on-screen instructions to save
your settings and exit the menus.
Parent topic: Wired Network Projection

Epson PowerLite E20 Specifications

General

Contrast Ratio	15, 000:1
Projection Technology	3LCD
Aspect Ratio	4:3
Keystone Correction	Vertical: ±30 degrees
Speaker	2W Mono
Color Reproduction	Up to 1.07 billion colors
Lamp Life	12000 hours (Eco mode)
Zoom Ratio	1.35x
Inputs	HDMI, VGA, Composite Video, USB Type-A, USB Type-B
Projection Size	30 inches - 350 inches
Brightness	3400 Lumens (Color), 3400 Lumens (White)
Resolution	XGA (1024 x 768)