Epson PP-100

Troubleshooting 72
Stacker 3 is not correctly inserted for Batch
Mode
Make sure that Stacker 3 is correctly inserted.
Stacker 1 is empty
Load discs into Stacker 1.
Note:
The stacker lamp flashes when the
source stacker is out of discs; however,
the timing of the light flashing may not
match with the timing of the stacker
becoming empty.
Stacker 2 is empty
Load discs into Stacker 2.
Note:
The stacker lamp flashes when the
source stacker is out of discs; however,
the timing of the light flashing may not
match with the timing of the stacker
becoming empty.
Stacker 1 is overloaded
Remove discs so that discs are below the red
line.
Stacker 2 is overloaded
Remove discs so that discs are below the red
line.
Stacker 3 is overloaded
Remove all the discs from Stacker 3.
Stacker 2 is full
Remove published discs from Stacker 2.
Stacker 3 is full
Remove published discs from Stacker 3.
Stacker 4 is full
Remove published discs from Stacker 4.
Stacker 4 is open
Close Stacker 4.
Lights Conditions/Remedies
Power Busy Error Ink Stacker
1 2 3 4