c
Important:
❏ You must remove the yellow tape from the cartridge before installing it; otherwise, print quality may
decline or you may not be able to print.
❏ If you have installed an ink cartridge without removing the yellow tape, take the cartridge out of the
product, remove the yellow tape, and then reinstall it.
❏ Do not remove the transparent seal from the bottom of the cartridge; otherwise, the cartridge may become
unusable.
❏ Do not remove or tear the label on the cartridge; otherwise, ink will leak.
F
Insert the cartridge and press it until it clicks.
G
Close the ink cartridge cover.
Press Check on the control panel of the product to check if the cartridges are installed correctly.
H
Close the scanner unit slowly. Ink charging starts.
Note:
❏ The power light continues to flash while the product is charging ink. Do not turn off the product during ink
charging. If the ink charging is incomplete, you may not be able to print.
❏ If you had to replace an ink cartridge during copying, to ensure copy quality after ink charging is finished, cancel
the job that is copying and start again from placing the originals.
Ink cartridge replacement is complete. The product will return to its previous status.
User’s Guide
Replacing Ink Cartridges
132
To Next Page
Loading...
Need help?
General