EasyManuals Logo

Epson RC180 Safety And Installation

Epson RC180
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
2. Installation
RC180 Safety and Installation Rev.18
40
2.4. Manipulator Installation
Installation and transportation of robots and robotic equipment shall be performed
by qualified personnel and should conform to all national and local codes.
For details, refer to the Manipulator manual.
Installation Precautions
Safeguard installation
: To ensure safety, a safeguard must be installed for the robot system. For
details on the safeguard, refer to the Installation and Design Precautions
in the Safety chapter of the EPSON RC+ User’s Guide.
Space between safeguard and Manipulator
: Install the Manipulator at a location with sufficient space so that a tool or
a work piece on the end effector does not reach a wall or a safeguard
when the Manipulator extends its arm fully while holding a work piece.
Installing the Manipulator at a location with insufficient space is
extremely hazardous and may result in serious bodily injury and/or severe
equipment damage to the robot system as a tool or a work piece may
collide with a wall and a safeguard.
Manipulator check before installation
: Before installing and operating the Manipulator, make sure that all
p
arts of the Manipulator are in place and have no external defects.
Missing or defective parts may cause improper operation of the
Manipulator. Improper operation of the Manipulator is extremely
hazardous and may result in serious bodily injury and/or severe
equipment damage to the robot system.
Side mounting and ceiling mounting
: When mounting the Manipulator on a wall or ceiling, secure the
Manipulator to the wall or ceiling that has enough strength and rigidity.
Mounting the Manipulator on a wall or ceiling that has insufficient
strength and rigidity is extremely hazardous and may result in serious
bodily injury and/or severe equipment damage to the robot system as
the Manipulator may fall or vibrate.
Side mounting and ceiling mounting
: When mounting the Manipulator on a wall or ceiling, for safety
purposes, attach the support to the Manipulator base to prevent the
Manipulator from falling. If the Manipulator falls, it is extremely
hazardous and may result in serious bodily injury and/or severe
equipment damage to the robot system.

Other manuals for Epson RC180

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson RC180 and is the answer not in the manual?

Epson RC180 Specifications

General IconGeneral
BrandEpson
ModelRC180
CategoryController
LanguageEnglish

Related product manuals