Epson RC700-A Maintenance Manual

Maintenance 8. Maintenance Parts Replacement Procedures
48 RC700 Series Maintenance Rev.3
Fan
2
Installation
(RC700
-A,
RC700DU-A)
(1)
Fix the new fan to the fan fixing plate.
(Mounting screw ×2)
At this point, tighten the screws diagonally. Be careful of the mounting
direction.
(2)
Mount the
regenerative resistance to the rear plate. (Mounting screw ×2)
Be careful of the mounting direction.
(3)
Mount the rear plate to the body.
(Mounting screw ×5)
(4)
Connect the regenerative module connector to the DMB.
(5)
Connect the
regenerative module connector to the DPB.
(6)
Connect the fan extension connector.
(7)
Bind the
15 V power supply cable and fan cable.
by the
cable tie
(AB150).
Leave 110 mm from the end of the cable tie in order not
to tighten the cables too
much.
Cut the excess part of the tie.
110 mm
(8)
Mount the Top Panel. (Mounting screw
×6)
(9)
Connect the power plug
. Turn ON the Controller and make sure that the
Controller
starts properly without any vibration or abnormal noise.
* Pay attention to the right and wrong sides of the fan when installing it.

Epson RC700-A Specifications

General

Brand	Epson
Model	RC700-A
Category	Controller
Language	English